Outback-power-systems MATE2 System Controller and Display Installation a Manuel d'utilisateur télécharger pdf (Page 76)

eAGSSetupmenucontainsthefollowinggeneralsettingsthatdenetheAGSroutines.

eMATEusestheAUXoutputofanFXorFLEXnetDCrelaytocontrolthegenerator.e

MATEisconnectedtothisFXeitherdirectlyorthroughaHUB.

IfaHUBisused:

• Usethe<INC> and <DEC>sokeystosettheAGSPortvaluetotheHUBFXorFLEXnet

DC Port controlling the generator.

IfnoHUBisusedandtheMATEisdirectlypluggedintoanFX,thentheAGSPortneedstobe

setto0(zero).

ADV/MATE/AGS/SETUP-------------

ags port: 0

DOWN AGS INC DEC

ADV/MATE/AGS/SETUP---------------

ags port: 3

DOWN AGS INC DEC

Example:

AMATEisconnectedtoaHUB-10thathasfour

FXsandthreeChargeControllersconnectedtoit.

eFXsarepluggedintoPorts1–4,aslabeledon

theHUB,andtheChargeControllersareplugged

intoPorts5–7.AnyFXcanhaveitsAUXoutput

wired to a relay whose contacts are wired to the

startingcircuitryofthegenerator.eAGSPort

mustbesettotheportofthechosenFX.

AersettingtheAGSPort,pressthe<DOWN>

sokey.enextscreenallowsyoutoenablethe

AGSMode.

AGS Port

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 131 132

Pas de commentaire

Outback-power-systems MATE2 System Controller and Display Installation a Manuel d'utilisateur Page 76