Outback-power-systems MATE2 System Controller and Display Installation a Manuel d'utilisateur télécharger pdf (Page 38)

Advancingerrors(thecountisincreasingontheDEBUGscreen)meantheHUBisnotnding

adevicethatwaspreviouslythere.Inorder,trythefollowing:

1. Checkthatthedevice’sDCbreakerisonandoperatingcorrectly,thatthedeviceitselfison,

andthattheCAT5cableconnectingthedevicetotheHUBispluggedinatbothends.en

re-pollthesystem(SETUPMATEPG2COMMREPOLL,seepage34)

2. ChecktheDEBUGscreentoconrmtheproblemissolved.

3. SwapHUBportswithanotherdevice,eachusingitsownCAT5cable.Re-pollthesystem

andcheckforerrorsoneachport.Iftheerrormoved,theproblemiswiththedeviceor

thecablebetweenthePortandthedevice.IftheerrorremainsonthesamePort,thenthe

problemiswiththeHUB.

4. TryconnectingtheMATEdirectlytothedevice.IftheMATErecognizesthedevice,the

problemcouldliewiththecableconnectingthedevicetotheHUBorwiththeHUBport

itself.Anunrecognizeddevicecoulditselfbedamaged.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 131 132

Pas de commentaire

Outback-power-systems MATE2 System Controller and Display Installation a Manuel d'utilisateur Page 38