Outback-power-systems MATE2 System Controller and Display Installation a Manuel d'utilisateur télécharger pdf (Page 63)

What it does:HBXModeallowscontrolovertheuseofgrid-suppliedpowerbasedonuser-

determinedbatteryvoltageandtimesetpoints.Ausercanmaximizerenewableenergyuseand

minimizetheuseofgrid-suppliedpowerthroughcarefulHBXusage.

eOutBackdefaultvalues*forHBX(24Vsystem)arethefollowing:

• Highvoltage—26volts

• Lowvoltage—24volts

• Timeforbothhighandlowsettings—onehour

Whenthebatteryvoltageremainsat26voltsforonehour,theFXwilldisconnectfromthe

gridandthesystemwillrunonbattery-suppliedpower.Ifthebatteryvoltagefallsto24volts

foronehour,theFXconnectstothegrid.Duringthisconnectedperiod,thegrid-suppliedAC

current will power the loads and recharge the batteries unless the user manually shuts o the

FXchargingfunctiono.Withthechargero,thegridwillonlypowertheloads,allowing

renewable energy sources to recharge the batteries. is avoids running the loads from the

batteriesandrepeatedlycharginganddischargingthemusingmoreexpensiveutilitypower.

To shut the charger function o:

• Pressthe<AC IN>hotkeythreetimesuntiltheCHARGERCONTROLscreenappears.

• Pressthe<OFF> so key.

*Doublethesevaluesfora48Vsystem;dividethembyonehalffora12Vsystem.ese

values are not temperature compensated.

HBX Mode

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 131 132

Pas de commentaire

Outback-power-systems MATE2 System Controller and Display Installation a Manuel d'utilisateur Page 63