Outback-power-systems FW-IOB-T-230/400VAC Input/Output/Bypass Assembly - Manuel d'utilisateur télécharger pdf (Page 7)

To install the FW-IOB-T-230/400VAC:

• Remove the appropriate quantity of breaker knockouts from the breaker bracket.

• Pull the yellow tabs out from each breaker.

• Install the breakers on the din rail to approximately match the openings in the breaker bracket.

• Hold the breaker bracket loosely against the breakers on the din rail; move the breakers as

needed so they line up with the openings in the breaker bracket.

• With the breakers positioned properly, lock the yellow tabs to secure the breakers to the din rail.

• Install the AC Breaker Bypass Slide Plate (see Figure 5).

Installing the FW-IOB-T-230/400VAC

Figure 4: AC Breaker Installation for FW-IOB-T-230/400VAC

Bypass Breakers Output Breakers Input Breakers

(installed upside down)

1 2 3 4 5 6 7 8

Pas de commentaire

Outback-power-systems FW-IOB-T-230/400VAC Input/Output/Bypass Assembly - Manuel d'utilisateur Page 7