Outback-power-systems FLEXware 1000 Users Guide Manuel d'utilisateur télécharger pdf (Page 9)

MX60 Installation

A FLEXware 1000 System installation includes up to four MX Charge Controllers which can be

mounted on both the top and side of the FW1000-DC. Newer MXs have rear knockouts allowing

them to be mounted directly to the side of the enclosure without the need for additional

mounting brackets. Mounting brackets are required for top installation of all MX models and for

side installation of less recent models..

Figure 12:

MX Charge Controller mounting options

Bracket screw locations are

shown below

Screw locations for directly attaching an

MX Charge Controller are shown below

Figure 4: Two mounting plates installed

Note: Check that both FW-MPs are level as per the FLEXware Mounting Plate Installation Manual. If

space is restricted, the FW-MPs can be installed vertically.

With the Mounting Plate and the hanging screws (for the FX Series Inverter/Chargers) installed,

install the FXs.

• Start with the top FX.

• Hang the FX on the hanging screws, but continue to hold onto it.

• Loosely install four M6 X 20 mm screws, included with the FW-MP, one in each corner; tighten

them when all four are installed and the FX is aligned.

• Install the remaining FXs in the same manner.

Hanging Straps

1000 Manual.indd, Spread 9 of 12 - Pages (16, 9) 11/22/06 11:07 AM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Pas de commentaire

Outback-power-systems FLEXware 1000 Users Guide Manuel d'utilisateur Page 9