Outback Power Systems HUB10 Manuel d'utilisateur télécharger pdf (Page 11)

4. Move the plug-in jumper from the series/parallel location to the three-phase location.

5. Replace the PCB and bottom cover, the snap on wiring cover, and all CAT5e cables..

For three-phase stacking using a HUB 10, follow the same disassembly and assembly instructions as for

a HUB 4, but note that the jumper is in a di erent location as shown below.

Series/Parallel location Three-Phase location

HUB 10 PCB

Plug-in jumper

Jumper in series/

parallel location

Jumper in

three-phase

location

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Outback Power Systems HUB10 Manuel d'utilisateur Page 11